RFX Motorcycle circuit breaker Honda Race Series CRF 250 R (ME10)

The RFX Race Series kill switches are OEM replacement parts.

Complete with the same fittings, fastenings, connectors, and cable lengths as the original part.

Available for a wide range of motorcycles.

Features:

• OEM replacement
• Accepts all original connectors
• OEM cable length

Installation instructions:

• Start by removing the front plate.
• Carefully cut the cable ties holding the start and stop switch cables on the handlebars, then unscrew the clamps and let them hang.
• Locate the switch connector on the bike; it is often near the steering column on the chassis but can sometimes be found under the tank.
• Detach the connector and remove the switch, noting the routing of the wiring.
• Clean the connector with an electrical contact cleaner.
• Lightly secure the new switch on the handlebars in the desired position.
• Route the wires as you did with the old switch and assemble the connector.
• Check that the wires are not taut by turning the handlebars fully; adjust if necessary.
• Reinstall the cable ties if possible, positioning the cables behind the handlebars to avoid damage from debris.
• Replace your front plate.

Specifications:

• weight (g): 50
• width (mm): 100
• height (mm): 40
• length (mm): 145
• volume (cm³): 580